A. laid washer level around the ventilated, dry work on stage, to the cleaning tank water, until clean cylinder under the horizontal plane, 35 mm advisable, and adding suitable amount of cleaning agent or dishwashing detergent.

    B. Connect the power plug of the cleaning machine to the single-phase 220V and 10A power supply, which must be reliably grounded (three holes).

    C. The left area of the machine control panel is the temperature control area, and the right side is the ultrasonic working time control area. The specific operation is as follows.

    D. Adjust the ultrasonic working time: after the power is switched on, rotate the right time control knob clockwise to set the working time value that needs to be cleaned. Loosen knob, the machine will work according to the set of cleaning time to start the countdown, cleaning time after completion of cleaning, repeatable when the machine is not cut off the power to spin the timer knob set work time, let the machine to repeat work for the next cleaning.

    E, adjust the working temperature (if necessary to select heating) : after turning on the power supply, turn to the left of the temperature set knob, if the temperature is lower than the set value of the liquid in the tank, the heating system began to work, when the set value is lower than the actual temperature, operation is invalid. When the heater is working for a period of time, the temperature of cleaning liquid in the tank is heated to the set temperature. You can set the knob to "OFF" position and turn OFF the heating function (the heating function is as low as possible to protect the ultrasonic circuit).

    F. Shutdown after work: after the cleaning is completed, if no further operation is required, turn the temperature knob to "OFF" and turn OFF the heating element. The ultrasonic timer knob is placed in the "OFF" position and the machine will stop working. Disconnect the power supply and remove the cleaning fluid after cooling to normal temperature and wipe the machine.